Electric Pump: Difference between revisions
SoccPuppet (talk | contribs) (→Calculations: updated numbers) |
SoccPuppet (talk | contribs) (→Trivia: energy used display is slightly different from actual use) |
||
| Line 47: | Line 47: | ||
==Trivia== | ==Trivia== | ||
* The energy usage displayed is actually per operation, not per tick, | * The energy usage displayed is actually per operation, not per tick. Combined with other intricacies in the code, this causes the energy consumption to be slightly lower than displayed. This is more noticeable with less speed upgrades. | ||
** For example, at 2 speed upgrades and no energy upgrades installed, the real energy consumed per tick is 120 FE/t, whereas the display states 126.49 FE/t. | |||
** In most cases this difference will be around 5%, except at 8 energy upgrades installed where the consumption is fully accurate. | |||
{{Mekanism}} | {{Mekanism}} | ||
Revision as of 22:27, 3 March 2024
The Electric Pump is a powered pump with an internal buffer of 10000mB worth of fluids. It can pump any fluid that is covered in the forge fluid dictionary and can be placed on a shoreline and will pump the fluid under it and anything fluid under it.
Contents
Crafting Recipe
|
|
| ||
|
|
| ||
|
|
|
Usage
Place the pump 1 block above or adjacent to a source block of any fluid you desire. From then on the pump will collect any source block of the fluid it can find, checking any block it can reach going along all flowing blocks of the liquid. In the end, the pump collects all source blocks originally connected to the block it was placed near. It collects 2000mb/s (100mb/t) of water and 20mb/s (1mb/t) of heavy water for a cost of 100 Jouls per operation (10 Jouls/t).
To collect heavy water, a Filter Upgrade must be installed into the pump.
Calculations
An operation for the pump is defined as taking in 1 bucket of fluid (10mb of heavy water) every 19 ticks without speed upgrades. The equation for speed upgrades is floor(19*max -x/8), where "max" is the maximum speed multiplier in the config. Below is a table for the default max of 10, along with calculated rates.
| # of upgrades | # of ticks per operation | Calculated Pump Rate (mb/t) |
|---|---|---|
| 0 | 19 | 52.6 |
| 1 | 14 | 71.43 |
| 2 | 10 | 100 |
| 3 | 8 | 125 |
| 4 | 6 | 166.7 |
| 5 | 4 | 250 |
| 6 | 3 | 333.3 |
| 7 | 2 | 500 |
| 8 | 1 | 1000 |
Trivia
- The energy usage displayed is actually per operation, not per tick. Combined with other intricacies in the code, this causes the energy consumption to be slightly lower than displayed. This is more noticeable with less speed upgrades.
- For example, at 2 speed upgrades and no energy upgrades installed, the real energy consumed per tick is 120 FE/t, whereas the display states 126.49 FE/t.
- In most cases this difference will be around 5%, except at 8 energy upgrades installed where the consumption is fully accurate.
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
