Throughput

Universal Cable, Pressurized Tube, Mechanical Pipe have in their tooltip both a capacity and pump rate. This page tries to clarify how this comes together.

In Mekanism v10, Universal Cables have no Pump Rate indicated. Their actual pump rate is equal to the capacity of a single cable block.

Definitions

For convenience, we will use the following terms for the remainder of this page:

• Pipe: applies to any cable, pipe or tube
• Network: is a series of pipes of the same type connected together
• Acceptor: container or power consumer receiving power, fluids or gases from the network (energy cubes, machines drawing power/fluids/gases, tank valves, etc.)
• Emitter: any source of power, fluids or gases connected to and sending its contents to the network

Pipe networks

When right clicking a pipe network with the Network Reader, we get this kind of output:

Empty pressurized tube network

• Transmitters: number of individual pipe blocks forming the network (this does not count any machine ejecting fluids/gases/power to the network)
• Acceptors: number of acceptors connected to the network
• Needed: this is just Capacity - Buffer (see below)
• Buffer: the contents of the pipe. The value can range from 0 (indicated as "none") up to Capacity.
• Throughput: the amount of power/fluids/gases that transit through the network per tick.
• Capacity: The total power/fluid/gases capacity of the network. This is equal to the number of transmitters multiplied by the capacity of an individual pipe block

Another example that shows a non-empty buffer and actual throughput:

mechanical pipe network

Note that a 0 value for the buffer means that the acceptors on the network drain it faster than the emitters send.

Throughput

Pressurized Tube tooltip

The tooltip of a pipe shows:

• Capacity: the capacity that individual pipe block contributes to the network
• Pump rate: how fast the pipe can accept/pull when set on "pull" with a Configurator

The power/fluids/gases transfer mechanics through a pipe network work as follows:

• A pipe network can accept up to its max capacity from emitters as fast as they try to send it if they are auto ejecting via pipes set on normal (not pull)
• A pipe network tries to eject its entire buffer evenly among all acceptors each tick

Supposing that all tubes in a network are set to normal (the default), the theoretical maximum throughput of the network is the minimum of:

• the network total capacity
• the sum of the connected emitters send rates
• the sum of the connected acceptors receive rate

As an example, the picture to the right shows the figures for an ultimate Pressurized Tube. A network formed of 6 Ultimate Pressurized Tubes would have a max throughput of 96000000 mB/t (6 times 16000000 mB/t).